LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Metal Collar Quick Connect Fitting Service >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oiling Male Pipe Ends (Metal Collar)
    GM12784Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fuel Pipe Fitting Caution .
  1. Apply a few drops of clean engine oil to the male pipe end.
    2. Fig 2: Assembling Connectors (Metal Collar)
    GM12786Courtesy of GENERAL MOTORS CORP.
  2. Push both sides of the fitting together in order to snap the retaining tabs into place.
    3. Fig 3: Ensuring Connection (Metal Collar) Is Secure
    GM12787Courtesy of GENERAL MOTORS CORP.
  3. Once installed, pull on both sides of the fitting in order to make sure the connection is secure.
    4. Fig 4: View Of Retainer At Fuel Feed Quick-Connect Fitting
    GM1555554Courtesy of GENERAL MOTORS CORP.
  4. Install the retainer to the fuel feed quick-connect fitting.
scientia non olet · About LEMON Manuals