Removal Procedure
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Clean the evaporative emission (EVAP) connections and surrounding areas prior to disconnecting the line in order the avoid possible system contamination.
- Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
- Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
- Remove the brake master cylinder and reposition. Refer to Master Cylinder Replacement .
- Disconnect the EVAP (2) line from the purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
- Open the fuel/brake pipe retainers (1).
- Remove the EVAP line from the fuel/brake pipe retainers (1).
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the fuel/brake line retainer bolt.
- Remove the EVAP line from the retainer.
- Remove the fuel/brake line push in retainer from the underbody.
- Remove the EVAP line from the retainer.
- Remove the fuel/brake line retainer bolts.
- Remove the EVAP line from the retainer.
- Open the fuel/brake line retainer (1).
- Remove the EVAP line from the retainer.
- Disconnect the EVAP (4) line from the fuel tank EVAP line (1). Refer to Plastic Collar Quick Connect Fitting Service .
- Remove the EVAP line.