LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Engine/Chassis >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Feed, EVAP & Fuel Tank Lines
    GM1554561Courtesy of GENERAL MOTORS CORP.
  1. Position the EVAP line.
  2. Connect the EVAP (4) line to the fuel tank EVAP line (1). Refer to Plastic Collar Quick Connect Fitting Service .
  3. Fig 2: View Of Rear Fuel/Brake Pipe Retainer
    GM1555277Courtesy of GENERAL MOTORS CORP.
  4. Install the EVAP line to the retainer.
  5. Close the fuel/brake line retainer (1).
  6. Fig 3: View Of Fuel/Brake Pipe Retainer Bolts
    GM1555275Courtesy of GENERAL MOTORS CORP.
  7. Install the EVAP line to the retainer.
  8. NOTE: Refer to Fastener Notice .
  9. Install the fuel/brake line retainer bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  10. Fig 4: View Of Fuel/Brake Line Push In Retainer
    GM1555273Courtesy of GENERAL MOTORS CORP.
  11. Install the EVAP line to the retainer.
  12. Install the fuel/brake line push in retainer to the underbody.
  13. Fig 5: View Of Fuel/Brake Line Retainer Bolt
    GM1555271Courtesy of GENERAL MOTORS CORP.
  14. Install the EVAP line to the retainer.
  15. Install the fuel/brake line retainer bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  16. Lower the vehicle.
  17. Fig 6: View Of Fuel/Brake Pipe Retainers
    GM1555269Courtesy of GENERAL MOTORS CORP.
  18. Install the EVAP line to the fuel/brake pipe retainers (1).
  19. Close the fuel/brake pipe retainers (1).
  20. Fig 7: View Of Fuel Feed Line & Evaporative Emission (EVAP) Line
    GM1551868Courtesy of GENERAL MOTORS CORP.
  21. Connect the EVAP (2) line to the fuel rail. Refer to Plastic Collar Quick Connect Fitting Service .
  22. Position and install the brake master cylinder. Refer to Master Cylinder Replacement .
  23. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  24. Install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .