LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Tank Lines
    GM1575957Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Disconnect the evaporative emission (EVAP) line (3) from the canister. Refer to Plastic Collar Quick Connect Fitting Service .
    3. Fig 2: Identifying EVAP Canister Hose & Clamp
    GM1575959Courtesy of GENERAL MOTORS CORP.
  3. Reposition the EVAP canister hose clamp.
  4. Remove the EVAP canister hose.
    5. Fig 3: Identifying EVAP Canister & Fuel Tank
    GM1575960Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the canister EVAP line from the fuel sender. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Squeeze the small retainer in front of the canister in order to disengage the canister.
  7. Remove the EVAP canister.
scientia non olet · About LEMON Manuals