LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of CKP Sensor & Bolt
    GM55322Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the CKP sensor bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: Identifying Crankshaft Position (CKP) Sensor Electrical Connector
    GM1554552Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP sensor electrical connector (1).
  4. Install the right exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (3.8L) or Exhaust Manifold Replacement - Right Side (RPO LY7) .
  5. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About LEMON Manuals