LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Pressure Sensor Electrical Connectors
    GM1551867Courtesy of GENERAL MOTORS CORP.
  1. If necessary, remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Disconnect the oil pressure sensor electrical connector (4).
    3. Fig 2: View Of Oil Pressure Sensor, Washer & Valve Lifter Oil Filter
    GM1402008Courtesy of GENERAL MOTORS CORP.
  3. Using J 41712  , remove the oil pressure sensor (706) and washer (707). See Special Tools .
scientia non olet · About LEMON Manuals