LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Engine Mount Strut Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Mount Strut
    GM1551861Courtesy of GENERAL MOTORS CORP.
  1. Remove the forward engine mount strut bolt (3) and nut (1).
  2. Remove the rear engine mount strut bolt (4) and nut (5).
  3. Remove the engine mount strut (2).
  4. Inspect the rubber in the engine mount strut for the following conditions:
    • Hardness
    • Splitting
    • Cracking
    5. Fig 2: View Of Engine Mount Strut Bracket (Body Side)
    GM1551863Courtesy of GENERAL MOTORS CORP.
  5. If necessary, remove the engine mount strut bracket bolts (body side).
  6. If necessary, remove the engine mount strut bracket (body side).
    7. Fig 3: View Of Engine Mount Strut Bracket (Engine Side)
    GM1551860Courtesy of GENERAL MOTORS CORP.
  7. Remove the heater pipe bracket bolt from the engine mount.
  8. If necessary, remove the engine mount strut bracket bolts (engine side).
  9. If necessary, remove the engine mount strut bracket (engine side).
scientia non olet · About LEMON Manuals