Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Lower Engine Mount

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the lower engine mount nuts.
Tighten: Tighten the nuts to 50 N.m (37 lb ft).
Lower the vehicle.

Fig 2: View Of Lower Engine Mount & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the engine mount bracket.
Install the engine mount bracket bolts.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).

Fig 3: View Of Lower Engine Mount

Courtesy of GENERAL MOTORS CORP.

Using the engine support fixture, lower the engine.
Remove the engine support fixture.
Install the upper engine mount nuts.
Tighten: Tighten the nuts to 50 N.m (37 lb ft).
Install the left exhaust manifold. Refer to Exhaust Manifold Installation - Left Side .
Install the engine mount strut. Refer to Engine Mount Strut Replacement .