LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Engine Mount Bracket Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Lower Engine Mount & Bolts
    GM1551854Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the engine mount bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 2: View Of Lower Engine Mount
    GM1551856Courtesy of GENERAL MOTORS CORP.
  3. Using the engine support fixture, lower the engine.
  4. Remove the engine support fixture.
  5. Install the upper engine mount nuts.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

  6. Install the left exhaust manifold. Refer to Exhaust Manifold Installation - Left Side .
  7. Install the engine mount strut. Refer to Engine Mount Strut Replacement .
scientia non olet · About LEMON Manuals