LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Drive Belt Idler Pulley
    GM1655077Courtesy of GENERAL MOTORS CORP.
  1. Position the necessary drive belt idler pulley to the coolant manifold and/or generator bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the necessary drive belt idler pulley bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals