Valve Rocker Arm Cover Installation - Right Side

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Valve Rocker Arm Cover Gasket

Courtesy of GENERAL MOTORS CORP.

IMPORTANT:

All gasket surfaces should be free of oil or other foreign material during assembly.
DO NOT use the valve rocker arm cover gasket again.
The valve rocker arm cover bolt grommets may be used again if not damaged.

Fig 2: View Of Valve Rocker Arm Cover

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the cover bolts with grommets.
Tighten: Tighten the valve rocker arm cover bolts to 12 N.m (106 lb in).

Fig 3: View Of Bracket, Bolts, Coils & Wire Harness

Courtesy of GENERAL MOTORS CORP.

Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the ignition coil bolts (723).
Install the ignition coils (722), wire harness (721), and bolts (723) to the bracket (719).
Tighten: Tighten the ignition coil bolts to 8 N.m (71 lb in).

Fig 4: View Of Ignition Coil & Bracket Assembly

Courtesy of GENERAL MOTORS CORP.

Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the ignition coil bracket studs (720).
Install the ignition coil and bracket assembly (719) and studs (720).
Tighten: Tighten the bracket studs to 12 N.m (106 lb in).