LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 5.3L) >> Repair Instructions - Off Vehicle >> Valve Lifter Oil Manifold Installation

Valve Lifter Oil Manifold Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Manifold Lift Caution
    GM1536553Courtesy of GENERAL MOTORS CORP.
  1. Do not lift the manifold assembly by the electrical lead frame.
    2. Fig 2: Valve Lifter Oil Manifold Gasket
    GM1402014Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • All gasket surfaces should be free of oil or other foreign material during assembly.
    • Do not allow dirt or debris to enter the oil passages of the manifold. Plug as required.
  2. Install the service gasket (556) onto the manifold.
    3. Fig 3: View Of Valve Lifter Oil Manifold
    GM1402004Courtesy of GENERAL MOTORS CORP.
  3. Install the manifold (451) with gasket.
    4. NOTE: Refer to Fastener Notice .
  4. Install the manifold bolts (506).

    Tighten:  Tighten the manifold bolts to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals