LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.6L (2 Of 5)) >> On-Vehicle Repair Information (1 Of 2) >> Engine Mount Bracket Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Mount Upper Nuts
    GM96010Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount bracket to the engine mount.
    2. NOTE: Refer to Fastener Notice .
  2. Install the engine mount upper nuts.

    Tighten:  Tighten the engine mount upper nuts to 53 N.m (39 lb ft).

  3. Install the engine mount. Refer to Engine Mount Replacement - Right Side .
scientia non olet · About LEMON Manuals