LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.6L (2 Of 5)) >> On-Vehicle Repair Information (1 Of 2) >> Drive Belt Idler Pulley Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Do not remove the belt from the air conditioning (A/C) compressor or water pump.
  1. Remove the drive belt from the generator. Refer to Drive Belt Replacement .
    2. Fig 1: Locating Drive Belt Idler Pulley
    GM1395993Courtesy of GENERAL MOTORS CORP.
  2. Remove the drive belt idler pulley bolt.
  3. Remove the drive belt idler pulley.
scientia non olet · About LEMON Manuals