LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 3.6L (5 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 3) >> Engine Flywheel Installation >> Installation

Engine Flywheel Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Place the engine flywheel in position on the crankshaft.
  2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.
    3. Fig 1: View Of Special Tool EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  3. Install the EN 46106  . See Special Tools .
    4. Fig 2: Identifying Engine Flywheel Bolts
    GM1395957Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the remaining NEW engine flywheel bolts.

    Tighten: 

    1. Tighten the NEW engine flywheel bolts to 30 N.m (22 lb ft).
    2. Tighten the NEW engine flywheel bolts an additional 45 degrees using the J 45059  .

    5. Fig 3: View Of Special Tool EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  5. Remove the EN 46106  . See Special Tools .
scientia non olet · About LEMON Manuals