LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 3.6L (5 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 3) >> Crankshaft and Bearing Installation >> Crankshaft Installation Procedure

Crankshaft Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Crankshaft Sprocket Drive Pin
    GM1864436Courtesy of GENERAL MOTORS CORP.
  1. If removed, install the crankshaft key. Lightly tap the key in place with a small soft face, bronze/plastic, hammer until it bottoms in the keyway.
    2. Fig 2: View Of Crankshaft
    GM1866875Courtesy of GENERAL MOTORS CORP.
  2. Gently lower the crankshaft into position in the cylinder block.
scientia non olet · About LEMON Manuals