LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Mechanical - 3.6L (4 Of 5)) >> Off-Vehicle Repair Instructions (2 Of 3) >> Engine Front Cover Disassemble >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Crankshaft Front Oil Seal & Removal Tool
    GM1950005Courtesy of GENERAL MOTORS CORP.
  1. Remove the crankshaft front oil seal from the engine front cover using the J 45000  . See Special Tools .
    2. Fig 2: Locating Camshaft Position Actuator Valve Oil Seals
    GM1408421Courtesy of GENERAL MOTORS CORP.
  2. Remove the camshaft position actuator valve oil seals from the engine front cover.
    3. Fig 3: Identifying Water Pump Seal
    GM1211002Courtesy of GENERAL MOTORS CORP.
  3. Remove the water pump seal from the engine front cover.
  4. Discard the water pump seal.
scientia non olet · About LEMON Manuals