LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Engine Front Cover Removal

Engine Front Cover Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Camshaft Position Actuator Valves
    GM1412163Courtesy of GENERAL MOTORS CORP.
  1. Remove the camshaft position actuator valve bolts.
  2. Remove the camshaft position actuator valves from the front cover.
    3. Fig 2: Locating Engine Front Cover Bolts
    GM1412164Courtesy of GENERAL MOTORS CORP.
  3. Remove the engine front cover bolts.
    4. Fig 3: Identifying Pry Points
    GM1412166Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not pry between the engine front cover and the camshaft position sensors or the camshaft position actuators in order to separate the RTV. Use the pry points and a bolt in the jackscrew hole in order to remove the engine front cover. Damage to the camshaft position sensors or the camshaft position actuators may occur if the camshaft position sensors or the camshaft position actuators are used to pry against in order to remove the engine front cover.
  4. Loosely install a 10 x 1.5 mm bolt in the jackscrew hole (1).
  5. Using the pry points (2) located at the edge of the front cover and the jackscrew, shear the room temperature vulcanizing (RTV) sealant.
    6. Fig 4: View Of Engine Front Cover
    GM1586271Courtesy of GENERAL MOTORS CORP.
  6. Remove the engine front cover.
scientia non olet · About LEMON Manuals