LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (3 Of 5)) >> ON-VEHICLE REPAIR INSTRUCTIONS (2 Of 2) >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Oil Pressure Sensor
    GM1401653Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the oil pressure sensor.

    Tighten:  Tighten the oil pressure sensor to 20 N.m (15 lb ft).

    2. Fig 2: Identifying Oil Pressure Sensor Electrical Connector
    GM1394025Courtesy of GENERAL MOTORS CORP.
  2. Connect the oil pressure sensor electrical connector.
scientia non olet · About LEMON Manuals