LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (3 Of 5)) >> ON-VEHICLE REPAIR INSTRUCTIONS (2 Of 2) >> Engine Oil Level Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Switch
    GM1213854Courtesy of GENERAL MOTORS CORP.
  1. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement .
  2. Disconnect the electrical connector from engine oil level switch.
  3. Remove the engine oil level switch from the oil pan.
scientia non olet · About LEMON Manuals