LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (3 Of 5)) >> ON-VEHICLE REPAIR INSTRUCTIONS (2 Of 2) >> Engine Oil Level Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Switch
    GM1213854Courtesy of GENERAL MOTORS CORP.
  1. Install the engine oil level switch to the oil pan.
    2. NOTE: Refer to Fastener Notice .
  2. Install the engine oil level switch bolt.

    Tighten:  Tighten the engine oil level switch bolt to 10 N.m (89 lb in).

  3. Connect the electrical connector to engine oil level switch.
  4. Fill the engine oil. Refer to Engine Oil and Oil Filter Replacement .
  5. Inspect for oil leaks after engine start up.
scientia non olet · About LEMON Manuals