LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (3 Of 5)) >> ON-VEHICLE REPAIR INSTRUCTIONS (2 Of 2) >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Flywheel
    GM902811Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission. Refer to Transmission Replacement .
  2. Remove the engine flywheel bolts and the flywheel. Refer to Engine Flywheel Removal .
  3. Clean and inspect the flywheel. Refer to Engine Flywheel Cleaning and Inspection . If the flywheel teeth are damaged, inspect the starter for proper operation. Replace the starter if there is excessive wear or damage to the starter drive. Refer to Starter Motor Replacement (LY7) .
scientia non olet · About LEMON Manuals