Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

Before the ECM can report DTC P2195 failed, DTCs P0030, P0031, P0032, P0036, P0037, P0038, P0053, P0101, P0130, P0131, P0132, P0133, P0135, P0137, P0138, P0140, P0141, P167A, P2231, P2237, P2243, P2251, P2270, P2271, P2297 and P2626 must run and pass.
The front and rear HO2S are at operating temperature.
The HO2S 2 voltage signal is greater than 850 mV.
The HO2S 1 is greater than 1.08 lambda.
The Loop Status for both the front and rear sensor is Closed Loop.
DTC P2195 runs continuously once the above conditions are met.