LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System & Fuel System - 3.6L - DTC P2105 To DTC P2626) >> DTC P2107 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON, observe the scan tool DTC information for 30 seconds. DTC P2107 should not set.
    • If DTC P2107 sets, replace the ECM.
  2. Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records Data List.