Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Carefully clean the throttle body mounting surfaces of any gasket and/or seal material.

Fig 1: View Of Throttle Body

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the throttle body bolts.
Tighten: Tighten the throttle body bolts to 10 N.m (89 lb in).

Fig 2: View Of Wiring Harness Conduit

Courtesy of GENERAL MOTORS CORP.

Fig 3: View Of Throttle Body Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the throttle body electrical connector.
Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .