LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAF Sensor
    GM1201263Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the mass air flow (MAF) electrical connector.
  3. Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
  4. Remove the MAF sensor fasteners.
  5. Remove the MAF sensor and the MAF sensor seal.
scientia non olet · About LEMON Manuals