LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAF Sensor
    GM1201263Courtesy of GENERAL MOTORS CORP.
  1. Install the new MAF sensor seal and the MAF sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the MAF sensor screws.

    Tighten:  Tighten the MAF sensor screws to 4 N.m (35 lb in).

  3. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
  4. Install the MAF electrical connector.
scientia non olet · About LEMON Manuals