LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Ignition Coils
    GM860797Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coils.
  2. NOTE: Refer to Fastener Notice .
  3. Install the ignition coil bolts.

    Tighten:  Tighten the ignition coil bolts to 10 N.m (89 lb in).

  4. Fig 2: View Of Ignition Coil Electrical Connectors
    GM887888Courtesy of GENERAL MOTORS CORP.
  5. Install the ignition coil electrical connectors.