Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Ignition Coils

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the ignition coil bolts.
Tighten: Tighten the ignition coil bolts to 10 N.m (89 lb in).

Fig 2: View Of Ignition Coil Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Install the ignition coil electrical connectors.
If necessary, install the intake manifold. Refer to Upper Intake Manifold Replacement .
Install the engine cover. Refer to Fuel Injector Sight Shield Replacement .