LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Chassis/Canister >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating EVAP And Fuel Tank Components
    GM699561Courtesy of GENERAL MOTORS CORP.
  1. Connect the EVAP purge pipe (8) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
    2. Fig 2: View Of Fuel Filter & Pipes
    GM699549Courtesy of GENERAL MOTORS CORP.
  2. Connect the EVAP purge pipe at the fuel filter area. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals