LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Evaporative Emission (EVAP) Canister Vent Solenoid Valve
    GM1396038Courtesy of GENERAL MOTORS CORP.
  1. Slide the EVAP canister vent solenoid on the EVAP canister vent bracket until the solenoid snaps into place.
  2. Connect the EVAP vent hose to the EVAP canister vent solenoid.
  3. Connect the EVAP canister vent solenoid harness connector.
  4. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals