LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating EVAP And Fuel Tank Components
    GM699561Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Disconnect the EVAP vent hose (6), the EVAP purge pipe (8), and the EVAP vapor pipe (7) from the EVAP canister (1). Refer to Plastic Collar Quick Connect Fitting Service .
    3. IMPORTANT: Replace the retaining strap when replacing the EVAP canister.
  3. Release the EVAP canister retaining strap.
  4. Remove the EVAP canister (1) from the fuel tank.
scientia non olet · About LEMON Manuals