LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating EVAP And Fuel Tank Components
    GM699561Courtesy of GENERAL MOTORS CORP.
  1. Position the EVAP canister (1) on the fuel tank.
  2. Install the new EVAP canister retaining strap.
    3. NOTE:
    • Do not attempt to straighten kinked nylon pipes. Replace any kinked nylon pipes in order to prevent damage to the vehicle.
    • Do not attempt to repair sections of nylon pipes. Replace damaged nylon pipes.
    • Replace the vapor pipes with original equipment or parts that meet GM specifications.
    • Replace the vapor hoses with original equipment or parts meeting GM specifications. Use only reinforced fuel-resistant hose identified with the word Fluoroelastomer or GM 6163M on the hose.
  3. Connect the EVAP vent hose (6), the EVAP purge pipe (8), and the EVAP vapor pipe (7) to the EVAP canister (1). Refer to Plastic Collar Quick Connect Fitting Service .
  4. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals