LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Purge Valve Solenoid
    GM1395512Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the purge valve solenoid to the intake manifold.

    Tighten:  Tighten the purge solenoid bolt to 10 N.m (89 lb in).

    2. Fig 2: Locating Purge Line From The Manifold Side Of The Purge Valve Solenoid
    GM1344143Courtesy of GENERAL MOTORS CORP.
  2. Connect the purge line to the manifold side of the purge valve solenoid.
    3. Fig 3: Identifying Purge Valve Solenoid Electrical Connector
    GM1394073Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the purge valve solenoid electrical connector.
    4. Fig 4: View Of Purge Line From The Purge Valve Solenoid
    GM1401467Courtesy of GENERAL MOTORS CORP.
  4. Connect the purge line to the purge valve solenoid.
scientia non olet · About LEMON Manuals