LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition OFF.
    2. Fig 1: View Of Right CMP Sensor Electrical Connector - Intake
    GM1285245Courtesy of GENERAL MOTORS CORP.
  2. Remove the camshaft position (CMP) sensor electrical connector.
    3. Fig 2: View Of Right CMP Sensor - Intake
    GM1285251Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
scientia non olet · About LEMON Manuals