LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition OFF.
    2. IMPORTANT: Do not remove the engine control module (ECM) from the ECM bracket.
    Do not remove the ECM redundant ground wire from the ECM.
  2. Remove the ECM bracket bolts and reposition the ECM bracket in order to provide access.
    3. Fig 1: View Of Right CMP Sensor Electrical Connector - Exhaust
    GM1285253Courtesy of GENERAL MOTORS CORP.
  3. Remove the camshaft position (CMP) sensor electrical connector.
    4. Fig 2: View Of Right CMP Sensor - Exhaust
    GM1285252Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP sensor bolt.
  5. Remove the CMP sensor.
scientia non olet · About LEMON Manuals