LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition OFF.
    2. IMPORTANT: Do not remove the engine control module (ECM) from the ECM bracket.
    Do not remove the ECM redundant ground wire from the ECM.
  2. Remove the ECM bracket bolts and reposition the ECM bracket in order to provide access.
    3. Fig 1: View Of Right CMP Actuator Valve Electrical Connector - Intake
    GM1285235Courtesy of GENERAL MOTORS CORP.
  3. Remove the camshaft position (CMP) actuator valve electrical connector.
    4. Fig 2: View Of Right CMP Actuator Valve - Intake
    GM1285237Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP actuator valve bolt.
  5. Remove the CMP actuator valve.
scientia non olet · About LEMON Manuals