LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Right CMP Actuator Valve - Intake
    GM1285237Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP actuator valve.
    2. NOTE: Refer to Fastener Notice .
  2. Install the CMP actuator valve bolt.

    Tighten:  Tighten the CMP actuator valve bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Right CMP Actuator Valve Electrical Connector - Intake
    GM1285235Courtesy of GENERAL MOTORS CORP.
  3. Install the CMP actuator valve electrical connector.
  4. Install the ECM bracket with the ECM. Refer to Engine Control Module Replacement .
scientia non olet · About LEMON Manuals