LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.
    2. Fig 1: View Of Right CMP Actuator Valve - Exhaust
    GM1285202Courtesy of GENERAL MOTORS CORP.
  2. Install the CMP actuator valve.
    3. NOTE: Refer to Fastener Notice .
  3. Install the CMP actuator valve bolt.

    Tighten:  Tighten the CMP actuator valve bolt to 10 N.m (89 lb in).

    4. Fig 2: View Of Right CMP Actuator Valve Electrical Connector - Exhaust
    GM1285201Courtesy of GENERAL MOTORS CORP.
  4. Install the CMP valve electrical connector.
scientia non olet · About LEMON Manuals