LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Barometric Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Barometric Pressure Sensor And Electrical Connector
    GM945437Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the sensor electrical connector.
    3. Fig 2: View Of BARO Sensor
    GM1285192Courtesy of GENERAL MOTORS CORP.
  3. Remove the barometric pressure sensor bolt.
  4. Remove the barometric pressure sensor.
scientia non olet · About LEMON Manuals