LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CXL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Inlet Duct Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Intake Air Duct
    GM1404636Courtesy of GENERAL MOTORS CORP.
  1. Install the air intake duct to the MAF sensor.
  2. Install the air cleaner intake duct to the throttle body.
  3. Connect the PCV tube to the air intake duct.
    4. NOTE: Refer to Fastener Notice .
  4. Tighten the air intake air duct clamps.

    Tighten:  Tighten the clamps to 2 N.m (18 lb in).

  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals