LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure (CANADA) V6-3.6L >> Repair and Diagnosis >> Powertrain Management >> Transmission Control Systems >> Sensors and Switches - Transmission and Drivetrain >> Sensors and Switches - A/T >> Transmission Speed Sensor >> Service and Repair

Transmission Speed Sensor: Service and Repair



Input Speed Sensor Replacement

Removal Procedure

1. Remove the case side cover. Refer to Control Valve Body Cover Replacement (Control Valve Body Cover Replacement).
2. Disconnect the input speed sensor electrical connector.




3. Remove the input speed sensor retaining clip (441).
4. Remove the input speed sensor (440).




5. Inspect the input speed sensor (440) for the following conditions:

* Damaged or missing magnet
* Damaged housing
* Bent or missing electrical terminals
* Damaged speed sensor clip (441)

Installation Procedure




1. Install the input speed sensor (440).
2. Install the input speed sensor retaining clip (441).
3. Connect the input speed sensor electrical connector.
4. Install the case side cover. Refer to Control Valve Body Cover Replacement (Control Valve Body Cover Replacement).

scientia non olet · About LEMON Manuals