Heater Hoses Replacement (LD8)

Fig 1: Removing/Installing Heater Hoses (LD8)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications Preliminary Procedure Drain the cooling system. Refer to Draining and Filling Cooling System (Static Fill) or Draining and Filling Cooling System (Vac-N-Fill) Remove the air cleaner intake duct. Refer to Air Cleaner Assembly Replacement
1	Heater Inlet and Outlet Pipe Assembly Tip: Using J 37097-A

Callout

Component Name

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications

Preliminary Procedure

Heater Inlet and Outlet Pipe Assembly
Tip: Using J 37097-A