LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls And Fuel - 4.6L - DTC P0351 To DTC P2440) >> DTC P0496 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Start the engine.
  2. Seal the EVAP system using the Purge/Seal function with a scan tool.
  3. Disconnect the EVAP purge pipe from the EVAP canister purge solenoid valve.
    • If the Fuel Tank Pressure Sensor is between -1 to +1 inch H2O, replace the EVAP canister purge solenoid valve.
  4. If the Fuel Tank Pressure Sensor parameter is NOT between -1 to +1 inch H2O, replace the FTP sensor.
scientia non olet · About LEMON Manuals