LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 4.6L - DTC P0016 To DTC P0341) >> DTC P0107 or P0108 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: The MAP sensor 5-volt reference circuit is spliced to other components of the vehicle.
  1. If DTC P0641 or P0651 are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle
  2. Verify the integrity of the entire air induction system by inspecting the following conditions:
    • Any damage to, or hairline fractures of, the MAP sensor housing
    • Loose or improper MAP sensor installation
    • Any vacuum leak
  3. Verify that restrictions do not exist in the MAP sensor port or vacuum source.
  4. Determine the current vehicle testing altitude.
  5. Ignition ON, observe the scan tool BARO Sensor parameter. Compare the parameter to the Altitude vs Barometric Pressure table. Refer to Altitude Versus Barometric Pressure .
  6. Use the scan tool and compare the MAP Sensor parameter to a known good vehicle under various operating conditions.
scientia non olet · About LEMON Manuals