LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Torque Converter Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View of Torque Converter Cover
    GM627396Courtesy of GENERAL MOTORS CORP.
  1. Install the torque converter cover.

    Tighten:  Tighten the cover bolt to 12 N.m (106 lb in).

  2. Install the engine-to-transmission brace and attaching bolts.

    Tighten:  Tighten the bolts to 47 N.m (35 lb ft).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals