LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Torque Converter Clutch/Cruise Control Release Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Brake Pedal & Stop Lamp Switch
    GM575743Courtesy of GENERAL MOTORS CORP.
  1. Remove the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  2. Rotate the upper switch (1) counterclockwise and remove the switch.
  3. Disconnect the upper switch electrical connector.
scientia non olet · About LEMON Manuals