LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Torque Converter Clutch/Cruise Control Release Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Brake Pedal & Stop Lamp Switch
    GM575743Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When installing the torque converter clutch/cruise control release switch, ensure that the brake pedal remains in the full up or at rest position.
  1. Connect the upper switch (1) electrical connector.
  2. Install the upper switch (1) into the upper retainer.
  3. Rotate the switch clockwise until fully seated.
  4. Adjust the switch. Refer to Torque Converter Clutch/Cruise Control Release Switch Adjustment .
  5. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About LEMON Manuals