LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Scavenge Screens and Seals Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View of Left Right Scavenger Screens
    GM97465Courtesy of GENERAL MOTORS CORP.
  1. Install the new left and right scavenger seals.
  2. Install the new left and right scavenger screens.
    3. Fig 2: View of Bottom Pan
    GM97463Courtesy of GENERAL MOTORS CORP.
  3. Install the bottom pan, seal, and bolts. Finger-tighten the bolts.
    4. Fig 3: View of Pan Bolts Sequence
    GM15495Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the pan bolts 3 times to the proper specification, in the sequence shown:

    Tighten: 

    1. Tighten the pan bolts to 3 N.m (27 lb in).
    2. Tighten the pan bolts to 6 N.m (53 lb in).
    3. Tighten the pan bolts to 12 N.m (106 lb in).

  5. Lower the vehicle.
  6. Add DEXRON-III transmission fluid as required.
scientia non olet · About LEMON Manuals