LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Final Drive Internal Gear Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Final Drive Internal Gear & Snap Ring
    GM687607Courtesy of GENERAL MOTORS CORP.
  1. Install the final drive internal gear (120).
  2. Install the final drive internal gear snap ring (135).
  3. Install the final drive carrier. Refer to Final Drive Assembly Replacement .
scientia non olet · About LEMON Manuals